plotRow [<numRows>] [next <group> <n> | lnext <group> <n> |
cnext <group> <n> | rnext <group> <n> | span <group> <start> <n> |
unit <unit> | blank <n> | fill]*
This is the main command for describing the network layout used in the Unit Viewer. It adds one or more rows of unit cells to the bottom of the layout. The actual drawing in the Unit Viewer is not changed until drawUnits is called or the Unit Viewer is refreshed.
The first optional argument specifies the number of rows that are to be produced by this command. Essentially, this is the number of times the subsequent commands are to be repeated and a new row produced. A value of * will cause the commands to be repeated as long as they result in at least one unit being displayed. If no value is specified, this defaults to 1.
With no additional arguments, plotRow will leave the
specified number of rows blank. Otherwise, any number of plot commands
may be given. Each command describes a layout block. The blocks
will be packed together from left to right on the row in the order in
which their commands are specified. Some blocks are of fixed width and
others are of flexible width. Each command may be abbreviated to its
first character.
next takes a group and an integer. It will plot the next n units of the group that have not already been plotted. Ordinarily, the width of the block created by this command is n. However, if there are no longer n unused units remaining, the width of the block will be the actual number of units plotted.
lnext is similar to next, but the width of the block created will always be n. If there are no longer n unused units remaining, those units plotted will be left-justified in the block and the rest of the block will be left blank.
cnext is identical to lnext except that units in partially full blocks will be centered within the block rather than left justified.
rnext is identical to lnext except that units in partially full blocks will be right rather than left justified.
span plots a range of n units from the group beginning with the unit whose number is given by start. The width of the block will always be n. If a unit in the span has already been plotted, its position will be blank.
unit plots a single unit in a block of width 1. The unit will be replotted even if it has already been plotted. In this case, a blank space will be left in its previous location in the layout.
blank creates an empty block of width n.
fill creates a block of variable width. Once all of the other blocks in the row have been created, if the total number of columns taken up by those blocks is less than the networks plotCol value, any fill blocks will be expanded roughly equally to take up any remaining space.
To layout groups hidden1 and hidden2 in two
columns of width 5 with a column one cell wide separating them and units
in the last row left justified within their blocks:
lens> plotRow * l hidden1 5 b 1 l hidden2 5
To plot units input:0 and input:9 at the left
and right of a row and then plot the first ten input units with spaces
where units 0 and 9 would have been:
lens> plotRow u input:0 f u input:9
lens> plotRow s input 0 10
To layout the entire network in columns of width two rather than in rows:
lens> plotRow * n input 2 b 1 n hidden 2 b 1 n output 2
To arrange a group of 86 units in a circle:
lens> set r 5.5
lens> for {set i 1} {$i < 2 * $r} {incr i} {
> plotRow f n input [expr 2 * sqrt(2 * $i * $r - $i * $i)] f }